Z-Development Board
€194.35
Developer relay panel that can be easily programmed using ST-link or J-link and supplemented with interfaces that the microcontroller does not have.
Description
This tool primarily functions as a developer panel. It can be easily programmed using an ST-link or J-link and supplements interfaces that the microcontroller does not have, such as RS-232, RS-485, or inputs and outputs that far exceed CMOS / TTL signal levels. Most of the legs of the microcontroller rout out to the side of the panel for free use. In addition to E, 5V, 3.3V and GND are routed in several places. However, this tool requires a professional user level.
Specifications:
| Type | Input |
| Applications | This tool can be used to perform control tasks and to implement/test development goals. |
| Key Features | Two input options (POE or single DC), Ethernet connection, 2 USB host management, modularity |
| Interface | GPIO,UART,USART,Ethernet,I2C,SPI,ADC,DAC,COMP,OPAMP,USB (FS,HS), I2S, CAN, FMC, SDMMC, MDIOS, QUDSPI,LTDC,DCMI. |
| Board size | 105×185 mm |
| Input voltage | via Ethernet connector POE (48V) or dc connector from 8V to 24V |
Specifications:
When supplying, two options are possible: POE (48V) and smooth DC supply. In the case of DC, it can be operated from any voltage up to 8V-24V and requires 10W of power. Both the 5V and 3.3V branches route to the panel. Both circuits can be loaded with 500mA separately, regardless of the auxiliary electronics.
Operating temperature: 5-50 ° C
Attention! The panel is ESD (electrostatic discharge) sensitive. Appropriate protection is needed before touching.
Connectors and setting options:
| Label | Name | Default | Description |
| LD1 | RX | – | Receive LED indicator |
| X23 | X23 | DC | Allows you to select where to supply the circuit. |
| T1 | T1 | – | Ethernet connector |
| X14 | X14 | – | DC power connector (up to 8V-24V) |
| X1 | X1 | – | external accessory panel connector |
| X2 | X2 | – | external accessory panel connector |
| X3 | X3 | – | external accessory panel connector |
| X4 | X4 | – | external accessory panel connector |
| X5 | X5 | – | external accessory panel connector |
| X6 | X6 | – | external accessory panel connector |
| J1 | J1 | – | USB host interface |
| J2 | J2 | – | USB host interface |
| X | X | – | Programming interface |
Necessities for assembly
- Phillips screwdriver.
- Depending on the application, a PC, as well as an Ethernet connection – or STM32 programmer (ST_Link), is required for commissioning.
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.